33.21 Reports Task Page

The Reports task page allows you to set up reports for your CFD simulation. Reports can be compiled for fluxes, forces, projected areas, surface and volume integrals, among others. SeeChapter  30 for more information.

Controls

Reports   displays a list of available report types in ANSYS FLUENT.

You can double-click an item in the Reports list to open the corresponding dialog box, or you can select the item in the list and click the Set Up... button.

Fluxes   - selecting this item and clicking the Set Up... button opens the Flux Reports dialog box.

Forces   - selecting this item and clicking the Set Up... button opens the Force Reports dialog box.

Projected Areas   - selecting this item and clicking the Set Up... button opens the Projected Surface Areas dialog box.

Surface Integrals   - selecting this item and clicking the Set Up... button opens the Surface Integrals dialog box.

Volume Integrals   - selecting this item and clicking the Set Up... button opens the Volume Integrals dialog box.

Discrete Phase   allows you to report on one of the following three report types:

Sample   - selecting this item and clicking the Set Up... button opens the Sample Trajectories dialog box.

Histogram   - selecting this item and clicking the Set Up... button opens the Trajectory Sample Histogram dialog box.

Summary   - selecting this item and clicking the Set Up... button opens the Particle Summary dialog box.

Heat Exchanger   - selecting this item and clicking the Set Up... button opens the Heat Exchanger Report dialog box.

Set Up...   opens the dialog box corresponding to the selected item in the Reports list.

Parameters...   opens the Parameters dialog box.