[ANSYS, Inc. Logo] return to home search
next up previous contents index

11.3.1 Setting Dynamic Mesh Modeling Parameters

To enable the dynamic mesh model, enable Dynamic Mesh in the Dynamic Mesh task page (Figure  11.3.1)

figure Dynamic Mesh figure figure Dynamic Mesh

If you are modeling in-cylinder motion, enable the In-Cylinder option. If you are going to use the six degrees of freedom solver, then enable the Six DOF option.

Next, you will need to select the appropriate mesh update methods, and set the associated parameters, as well as the in-cylinder or Six DOF parameters, if relevant.

Figure 11.3.1: The Dynamic Mesh Task Page

next up previous contents index Previous: 11.3 Using Dynamic Meshes
Up: 11.3 Using Dynamic Meshes
Next: 11.3.2 Dynamic Mesh Update
Release 12.0 © ANSYS, Inc. 2009-01-29