33.9.6 Dynamic Mesh Events Dialog Box

The Dynamic Mesh Events dialog box is available to control the timing of specific events during the course of the simulation. See Section  11.3.8 for details.

Controls

Number of Events   specifies the number of events to be defined.

On   enables the corresponding event.

Name   specifies the name of the event.

At Crank Angle   specifies the angular location of the crank at which the event should occur. This option appears for in-cylinder flows.

At Time   specifies the time (in seconds) at which you want the event to occur. This option appears for non-in-cylinder flows.

Define...   opens the Define Event dialog box.

Read...   opens the Select File dialog box (see Section  2.1.6).

Write...   opens the Select File dialog box (see Section  2.1.6).

Preview...   opens the Events Preview dialog box.