ANSYS FLUENT 12.0 User's Guide - 24. Modeling Multiphase Flows

24. Modeling Multiphase Flows

This chapter discusses the general multiphase models that are available in ANSYS FLUENT. Section 24.1 provides a brief introduction to multiphase modeling, Chapter 23 discusses the Lagrangian dispersed phase model, and Chapter 25 describes ANSYS FLUENT's model for solidification and melting. For information about the various theories behind the general multiphase models in ANSYS FLUENT, see this chapter in the separate Theory Guide. Information about using the general multiphase models in ANSYS FLUENT is presented in the following sections:

24.1 Introduction
24.2 Steps for Using a Multiphase Model
24.3 Setting Up the VOF Model
24.4 Setting Up the Mixture Model
24.5 Setting Up the Eulerian Model
24.6 Setting Up the Wet Steam Model
24.7 Solution Strategies for Multiphase Modeling
24.8 Postprocessing for Multiphase Modeling

Previous: 23.8 Parallel Processing for
Up: ANSYS FLUENT 12.0 User's Guide
Next: 24.1 Introduction