34.2.11 Mesh/Separate/Cells...

The Mesh/Separate/Cells... menu item opens the Separate Cell Zones dialog box.

Separate Cell Zones Dialog Box

The Separate Cell Zones dialog box allows you to separate a single cell zone into multiple zones of the same type. See Section  6.8.2 for details.

Controls

Options   specifies the method on which the cell-zone separation is to be based.

Mark   indicates that the cell zone is to be separated based on the marks stored in adaption registers.

Region   indicates that the cell zone is to be separated into two or more contiguous regions based on an internal boundary within the original zone.

Registers   contains a list of defined adaption registers. If you are separating the cell zone by mark, select the adaption register to be used in the Registers list. When the separation is performed, cells that are marked will be placed into a new zone.

Zones   contains a list of cell zones from which you can select the zone to be separated.

Separate   separates the selected cell zone based on the specified parameters.

Report   reports what the result of the separation will be without actually separating the cell zone.