Manual pages | Cast3M

$$$$ TOUR     NOTICE  CHAT      11/09/12    21:18:21     7124           
                                             DATE     11/09/12

    Operateur TOUR                           Voir aussi : PLUS MOIN
    --------------                                        DEDU   

         OBJ2 = OBJ1 TOUR FLOT1 POIN1 (POIN2 si 3D) ;

         NOBJ1 ...  NOBJN = OBJ1  ... OBJN TOUR
                                         FLOT1 POIN1 (POIN2 si 3D) ;



    Description:
    ____________
 
    The TOUR operator creates an object which geometrical support
    is obtained from the rotation around a point or an axis of the
    geometrical support of an operand, and eventually which components
    may depend on the operand components from the same rotation.

    When the operator applies simultaneously to several operands,
    the elementary geometries are only transformed once.

    When the operand is either a CHPOINT whose components are
       'UX' 'UY 'UZ' or 'FX' 'FY' 'FZ' or
       'RX' 'RY' 'RZ' or 'MX' 'MY' 'MZ',
    or a MCHAML whose components are
       'SMXX' 'SMYY' 'SMZZ' 'SMXY' 'SMXZ' 'SMYZ' or
       'EPXX' 'EPYY' 'EPZZ' 'EPXY' 'EPXZ' 'EPYZ',
    these also undergo the rotation, while other components remain
    unchanged.

    This operator is non available in DIMEnsion 1 (no interest).


    Contents:
    _________

      OBJ1 : POINT or MAILLAGE or CHPOINT or MCHAML or MMODEL types.
             OBJ1 may also be a TABLE. In that case all objects in the 
             table must be of one of the types above and each one will 
             be receive the translation or the transformation.If a 
             TABLE is given it must be the only input object.

      FLOT1 : FLOTTANT type, amplitude of rotation in degrees

      POIN1, POIN2 : POINT type, center of rotation when 2D, axis when 3D

      OBJ2 : result of the same type than OBJ1

      OBJ1 ... OBJN : see OBJ1

      NOBJ1 ... NOBN : results respectively of the same types than  OBJ1 ... OBJ